A Lot of Fuss


I cannot believe they are having such a fit about the 3D printers and the Liberator.

They forced Defcad to take it down and immediately The Pirate Bay and a hundred other sites had it up.

They will never be able to put this genie back in the bottle. I think the tantrums they are having are going a long way to encourage additional designs to come out.

Lots of classic zip gun designs are resurfacing. Lots of people are going to be making runs to Home Depot.

If you buy a 3D printer or a drill press are you going to end up on a list.

You think the government is going to realize that gun smithing in general is not that complicated?

--Keep screaming, stamping your feet, and trying to stop the signal...

2 comments:

Old NFO said...

Much less how easy it is to make a single barrel shotgun out of pipe... Just sayin...

Bubblehead Les. said...

Well, since one can get the dimensions of that .380 Cartridge out of any could Reloading Manual, one could replicate the rest of the 3D Gun just by overlaying a Grid and getting the Length and Width. Well within the skill level of a Good Machinist or Pattern Maker.

So Take That, Obama!